How To Paint Safely On A Pitched Roof

How to Paint on a Steep Roof

If your business firm has a roof that overhangs some other roof, soffit, fascia, and possibly siding will need painting at some signal. Painting this section of your house that has a steep roof is impossible without a way to safely stay on it.

Steep roofs complicate home improvement tasks.

There is a simple, inexpensive method that will allow you to safely work off your roof and access the areas you need to pigment.

Tip

As a more expensive alternative, purchase two roof jack brackets, screw them to your roof 4 feet apart, and lay a 6-human foot-long, two-by-vi-inch lath across the brackets. The feet of your ladder will rest on the board. Use a clear roof patch in a tube to seal the screw holes when you remove your anchor lath or brackets.

Warning

Do not use nails to secure your boards together, or to secure your boards to your roof. Nails are not as safe as deck screws, and they tin can work loose.

If you are uncomfortable or nervous, go off your roof. Doing your own painting is not worth the chance of possible death or serious injuries if y'all fall.

Marker the middle of your two-by-four-inch board, using a record measure out and pencil. The center of an 8-pes-long board is 48 inches. Place a straight edge next to your pencil marks. Use your pencil to trace a line upwardly against your straight border.
Cut your 2-by-4-inch board in half with the circular saw.
Clench your ii, iv-foot sections together in the shape of an 50. Lay one board flat with the 4-inch side facing up, and set your 2d section of forest direct up against the side of the commencement board, with the 2-inch side facing up. The 4-inch side of the 2nd board should be up confronting the 2-inch edge of the beginning board.
Drive three-inch deck screws, with your drill, through the 4-inch side of the second board, into the 2-inch edge of the first board. Space your screws a maximum of vi inches apart.
Ready an extension ladder upwardly against your house in the expanse that you will exist working. Accept your drill, at least 6 iii-inch deck screws, and your L board up the ladder with you. Gear up your L board on your roof with the tallest side sticking up. Slide your board over so that it is a minimum of 2 feet from the side of the house or overhang you volition be working on. You practise not want to exist positioned too shut, or too far abroad.
Drive your deck screws through the face of the bottom board and into the roof.
Carry your second extension ladder upward to your roof and set the feet of your ladder up against the portion of board sticking upward off the roof. You lot volition now be able to climb onto your board and extend your ladder up your roof. Brand sure your ladder is locked into position before you become on it.

The Drip Cap

If your house has a roof that overhangs some other roof, soffit, fascia, and mayhap siding will demand painting at some point.
The eye of an viii-foot-long board is 48 inches.
Cut your 2-past-4-inch board in one-half with the circular saw.
Slide your board over and then that information technology is a minimum of 2 anxiety from the side of the house or overhang you volition be working on.
You do not want to be positioned too close, or likewise far abroad.